• EI
  • Scopus
  • 中国科技期刊卓越行动计划项目资助期刊
  • 北大核心期刊
  • DOAJ
  • EBSCO
  • 中国核心学术期刊RCCSE A+
  • 中国精品科技期刊
  • JST China
  • FSTA
  • 中国农林核心期刊
  • 中国科技核心期刊CSTPCD
  • CA
  • WJCI
  • 食品科学与工程领域高质量科技期刊分级目录第一方阵T1
中国精品科技期刊2020
李晓洁,刘金鑫,李建华,等. 大孔吸附树脂纯化茶多酚的工艺优化及抗氧化活性研究[J]. 华体会体育,2023,44(13):214−223. doi: 10.13386/j.issn1002-0306.2022090164.
引用本文: 李晓洁,刘金鑫,李建华,等. 大孔吸附树脂纯化茶多酚的工艺优化及抗氧化活性研究[J]. 华体会体育,2023,44(13):214−223. doi: 10.13386/j.issn1002-0306.2022090164.
LI Xiaojie, LIU Jinxin, LI Jianhua, et al. Optimization of Purification of Tea Polyphenols with Macroporous Adsorption Resin and Research of Their Antioxidant Activity[J]. Science and Technology of Food Industry, 2023, 44(13): 214−223. (in Chinese with English abstract). doi: 10.13386/j.issn1002-0306.2022090164.
Citation: LI Xiaojie, LIU Jinxin, LI Jianhua, et al. Optimization of Purification of Tea Polyphenols with Macroporous Adsorption Resin and Research of Their Antioxidant Activity[J]. Science and Technology of Food Industry, 2023, 44(13): 214−223. (in Chinese with English abstract). doi: 10.13386/j.issn1002-0306.2022090164.

大孔吸附树脂纯化茶多酚的工艺优化及抗氧化活性研究

Optimization of Purification of Tea Polyphenols with Macroporous Adsorption Resin and Research of Their Antioxidant Activity

  • 摘要: 为优化大孔吸附树脂纯化茶多酚的最佳工艺条件,通过对比14种不同类型大孔吸附树脂的静态吸附-解吸特性,在筛选出适宜的树脂型号后,利用单因素与响应面试验确定最佳提纯工艺要求,并进一步考察了树脂的重复使用和再生次数。同时,以VC为对照采用体外实验考察纯化前、后茶多酚的抗氧化活性。结果表明,LX-8树脂对茶多酚的吸附-解吸效果最好,可重复使用5次、再生6次。其最佳纯化工艺条件:100 mL浓度为6.4 mg/mL,pH5.4的茶汤以1.0 mL/min流速上样至LX-8树脂后,经180 mL 76%乙醇溶液以1.0 mL/min流速解吸,在该条件下茶多酚的回收率为86.9%,纯度为74.6%。体外抗氧化活性试验结果表明,纯化后茶多酚的总抗氧化能力、清除DPPH·和·OH的能力均有显著性增加,且随着浓度的增大,其抗氧化能力增强,其总抗氧化能力(1 mg/mL)为80.59 U/mL,对DPPH·和·OH清除能力的IC50值分别为0.0326和0.4167 mg/mL。虽然低于VC的抗氧化活性,但均高于纯化前的茶多酚,说明通过该工艺,能够显著提高茶多酚的抗氧化活性,且当纯化后茶多酚浓度为1 mg/mL时,其DPPH·清除率已经接近VC的DPPH·清除率,本研究为茶多酚的工业化生产和开发利用提供理论参考。

     

    Abstract: To optimize the technical condition for purification of tea polyphenols with macroporous adsorption resin, the static adsorption and desorption performance of macroporous adsorption resin of fourteen types were compared to select the best type of resin. The optimal purification process conditions were determined by single factor and response surface experiments, and the reuse and regeneration times of the resin were further investigated. Meanwhile, the antioxidant activities of tea polyphenols before and after purification were investigated by in vitro experiments with VC as the control. The results showed that LX-8 resin had the best adsorption-desorption effect on tea polyphenols, which could be reused 5 times and regenerated 6 times. The optimum purification conditions were as below: The sample concentration of 6.4 mg/mL, the sample pH value of 5.4, the loading volume of 100 mL, the sample flow rate of 1.0 mL/min, ethanol concentration of 76% eluting agent volume of 180 mL, and desorption rate of 1.0 mL/min. Under these conditions, the recovery rate of tea polyphenols was 86.9% and the purity was 74.6%. In vitro antioxidant activity studies revealed that the total antioxidant capacity, DPPH· scavenging capacity and ·OH scavenging capacity of the purified tea polyphenols were significantly increased. And with the increase of polyphenol concentration, its antioxidant capacity enhanced. The total antioxidant capacity of the purified tea polyphenol (1 mg/mL) was 80.59 U/mL. The IC50 of the purified tea polyphenol on scavenging ability of DPPH· and ·OH were 0.0326 and 0.4167 mg/mL respectively. Although the antioxidant activity of pure extract was lower than that of VC, it was higher than that of crude extract, indicating that the antioxidant activity of tea polyphenols could be significantly improved by this process, and when the concentration of the purified tea polyphenol was 1 mg/mL, its DPPH· scavenging rate was close to that of VC. This research provided a theoretical reference for the industrial production and utilization of tea polyphenols.

     

/

返回文章
返回